1. You should speed up to go through the railway crossing in this case.
A. Right
B. Wrong
Answer：B
2. What is the max speed when passing a level crossing?
A. 15km/hr
B. 20km/hr
C. 30km/hr
D. 40km/hr
Answer：C
3. A driver should observe the dynamic situation of the rear side vehicles before driving into the traffic flow from other road.
A. Right
B. Wrong
Answer：A
4. When the road maintenance vehicle and the engineering vehicle are on duty, the passing vehicles should avoid with care.
A. Right
B. Wrong
Answer：A
5. What marking is the combination of the white broken lines and the triangle area?
A. road entry marking
B. lane-dividing line that can be crossed
C. deceleration line at road entry
D. road exit marking
Answer：A
6. What marking is the white polylines in the circle?
A. ascertaining the distance between the vehicles
B. driving at reduced speed
C. ascertaining the speed of the vehicles
D. reducing the speed at the intersection
Answer：A
7. It lights if left door is not closed.
A. Right
B. Wrong
Answer：B
8. Whats the meaning of this sign?
A. expressway next exit ahead
B. expressway right exit ahead
C. expressway left exit ahead
D. expressway destination indication
Answer：C
9. The continuously flashing yellow light means that the vehicle may speed up and pass.
A. Right
B. Wrong
Answer：B
10. When a vehicle runs on an expressway, the driver may ascertain the speed according to his feeling.
A. Right
B. Wrong
Answer：B
11. This sign indicates obstacle ahead and bypassing from left side.
A. Right
B. Wrong
Answer：A
12. Continuously using the foot brake on a long downhill road ________.
A. Can shorten the engines service life
B. Increases the drivers labor intensity
C. Can drastically reduce the braking efficiency due to the rising temperature of the brake
D. Can easily cause vehicle overturn
Answer：C
13. How to use lights at this position?
A. turn on the right-turn signal
B. turn on the left-turn signal
C. turn on the hazard lights
D. turn on the head lights
Answer：B
14. Before a vehicle enters an intersection, the driver should reduce speed, observe and make sure it is safe to do so.
A. Right
B. Wrong
Answer：A
15. Whats the meaning of this sign?
A. watch for two-way road
B. driving by either side of the road
C. watch for variable lane
D. variable lane
Answer：C
16. When a motorized vehicle crosses a non-motorized vehicle on a narrow road or a narrow bridge at night, the motorized vehicle should use the high beam light.
A. Right
B. Wrong
Answer：B
17. Whats the meaning of this sign?
A. indication of the place name of the expressway ending
B. indication of the driving route of the expressway
C. indication of the driving direction of the expressway
D. indication of the location and distance of the expressway
Answer：D
18. Driving motor vehicle with ABS system may occur side skidding when applying emergency braking.
A. Right
B. Wrong
Answer：A
19. It lights to indicate that ______
A. not buckled up
B. safety belt malfunction
C. the safety belts are too loose
D. buckled up already
Answer：A
20. Whats the meaning of this sign?
A. special lane for small vehicles
B. special lane for motorized vehicles
C. special lane for taxis
D. special lane for multi-passenger vehicles
Answer：D
21. You can make an U turn at this intersection.
A. Right
B. Wrong
Answer：B
22. The passenger in the front seat does not need to buckle up when a motorized vehicle runs.
A. Right
B. Wrong
Answer：B
23. What is the max speed on a road covered by ice and snow
A. 50km/hr
B. 40km/hr
C. 30km/hr
D. 20km/hr
Answer：C
24. When driving at night on a road with no or poor lighting, the driver should switch from the low beam light to the high beam light. But the vehicle following in the same direction is not allowed to use the high beam light.
A. Right
B. Wrong
Answer：A
25. How far away should the warning sign be placed in the coming direction when this vehicle breaks down and stops temporarily on the expressway?
A. beyond 150m
B. 50~150m
C. within 50m
D. 50~100m
Answer：A
