1. Which part does this switch control?
A. windscreen defogger
B. windscreen wiper
C. the hazard lights
D. devices of lights and signals
Answer：B
2. Whats the meaning of this sign?
A. the distance from the tunnel exit
B. the distance from the tunnel entry
C. the distance of following the vehicle in front in the tunnel
D. the whole length of the tunnel
Answer：A
3. It lights continuously to indicate that engine control system failed.
A. Right
B. Wrong
Answer：A
4. This sign reminds the road in front changes to inseparate two ways section.
A. Right
B. Wrong
Answer：A
5. Whats the meaning of this guide arrow?
A. indicate turning left or making a U turn ahead
B. indicate going straight or turning left ahead
C. indicate going straight or changing to left lane ahead
D. indicate going straight or making a U turn ahead
Answer：D
6. When a vehicle enters a two-way tunnel, the driver should turn on ________.
A. The hazard lights
B. The high beam light
C. The fog light
D. The width light or the low beam light
Answer：D
7. At this position, you may speed up to pass through the section.
A. Right
B. Wrong
Answer：B
8. When driving at night on a road that has good lighting, the driver should use _______.
A. The fog light
B. The low beam light
C. The high beam light
D. The hazard lights
Answer：B
9. This sign indicates landslide section ahead and bypassing.
A. Right
B. Wrong
Answer：B
10. What is this instrument?
A. pressure meter
B. ammeter
C. water temperature meter
D. fuel meter
Answer：D
11. When a following vehicle gives the overtaking signal, the driver should ________ if conditions permit.
A. Move to the right side and speed up
B. Voluntarily reduce speed and drive along the right side
C. Yield a proper space and speed up
D. Reduce speed rapidly or apply an emergency braking
Answer：B
12. Whats the meaning of this sign?
A. line guide signs
B. lane merging guide signs
C. lane branching guide signs
D. turning guide signs
Answer：A
13. What marking is the combination of the white broken lines and the triangle area?
A. road entry marking
B. lane-dividing line that can be crossed
C. deceleration line at road entry
D. road exit marking
Answer：A
14. What is the max speed when passing this curve?
A. 40km/hr
B. 30km/hr
C. 50km/hr
D. 70km/hr
Answer：B
15. What is the max speed on this expressway?
A. 60km/hr
B. 90km/hr
C. 90km/hr
D. 120km/hr
Answer：D
16. A driver should observe the dynamic situation of the rear side vehicles before driving into the traffic flow from other road.
A. Right
B. Wrong
Answer：A
17. If a motorized vehicle causes a traffic accident on the road, the driver should immediately move the vehicle to the roadside.
A. Right
B. Wrong
Answer：B
18. The main impact of mountain roads on safe driving is _______.
A. The traffic conditions are boring
B. The slopes are long, the curves are sharp and visibility range is shorter.
C. The traffic flow is heavy
D. The road signs are fewer
Answer：B
19. No turning left in this situation.
A. Right
B. Wrong
Answer：A
20. Whats the meaning of this sign?
A. left-turn lane
B. straight-going lane
C. right-turn lane
D. lanes for going in different directions
Answer：D
21. Whats the meaning of this sign?
A. stop to get card
B. stop to pay
C. ETC lane
D. stop for inspection
Answer：A
22. Before a vehicle enters an intersection, the driver should reduce speed, observe and make sure it is safe to do so.
A. Right
B. Wrong
Answer：A
23. What is this traffic sign?
A. Road narrows on both sides
B. Road narrows on the right side
C. Road narrows on the left side
D. Bridge narrows
Answer：B
24. A driver should buckled up before the vehicle moves.
A. Right
B. Wrong
Answer：A
25. Whats the meaning of this sign?
A. the lane for non-motorized vehicles
B. yield non-motorized vehicles
C. no passing for non-motorized vehicles
D. watch for non-motorized vehicles
Answer：D
